How To Reset Ruud Furnace

Resetting your furnace is a relatively simple process that can be completed in a few minutes. This process will clear any errors that may have occurred and reset the furnace to its factory settings.

How To Reset Ruud Furnace

If your Ruud furnace is not working, you may need to reset it. Resetting the furnace can be done by disconnecting the power to it for a few minutes and then reconnecting it.

-Phillips head screwdriver -flat head screwdriver -wrench -hammer -putty knife -scraper -resetting tool

  • Check the breaker for your furnace to make sure it is turned on
  • If the breaker is on, reset the furnace by turning it off and then back on
  • If the furnace does not reset, wait about

-If your Ruud furnace is not working, you may need to reset it. -To reset the furnace, locate the breaker for the furnace and switch it off for a minute. -After a minute, switch the breaker back on and wait for the furnace to restart.

Frequently Asked Questions

Where Is Furnace Reset Button?

There is no furnace reset button.

How Do You Manually Reset A Furnace?

If your furnace is not igniting, you may need to manually reset it. Check your furnace’s owner’s manual for the location of the manual reset switch. Once you have located it, press and hold the switch for a few seconds until the furnace turns off. Release the switch and wait a few minutes before trying to ignite the furnace again.

How Do You Force A Furnace To Restart?

There are a few ways to force a furnace to restart. One is to turn off the power to the furnace, wait a minute, and then turn the power back on. Another is to open the furnace door and hit the reset button.


If the furnace is not resetting, it may be due to a problem with the thermostat. First, make sure the thermostat is set to “heat.” Second, check the batteries in the thermostat. If the furnace still does not reset, it may be due to a problem with the circuit board. In this case, you should call a technician.

Leave a Comment

Your email address will not be published. Required fields are marked *